I spoke with Lippert about the Lippert Components Kwikee Step Frame 28 Series Step part # LC3747457 and unfortunately, they do not provide any mounting information as this is done through the trailer manufacturer. They did however state that you should not have too many issues so long as the surface in which the steps attach to is sturdy.
Please note that the above part is for the frame only, if you need the motor/control board etc. then you would want to use the Lippert Kwikee 38 Series... view full answer...
The Andersen Camper Wheel Chock and Leveler part # AM3604 can be used on the front or rear axle of a motorhome, it all really depends on the terrain in regards to where and how many you need. That said, keeping a few sets onboard is never a bad idea. view full answer...
I was able to locate the instructions for the Rear View Safety Clearance Light Backup Camera # RVS-921 for you and have listed the steps for installation of this clearance light backup camera for you below.
1. Locate and mark camera mounting position at rear of vehicle.
2. Drill hole (0.375") in vehicle to run cabling through.
3. Stick adhesive pad onto back of camera.
4. Disconnect 5 pin connection, fish wiring through hole then reattach 5 pin connection.
5. Mount camera with adhesive... view full answer...
Adco Windshield Cover # 290-2411 does sort of lock to the vehicle. The project manager for this product told me that it has sewn-in door pockets that slip over the corners of each door. When the cover is installed and the door is closed the cover cannot be removed making this an anti-theft feature. The rest of the cover stays in place using magnets. It isn't insulated either. Since it installs on the exterior of the vehicle insulation wouldn't do much good. It is primarily used to keep... view full answer...
Go To Results